Configuring Hyprland
The config is located in ~/.config/hypr/hyprland.conf.
Hyprland will automatically generate an example config for you if you don’t have one.
By removing the line autogenerated=1 you’ll remove the yellow warning.
There is no “reload” keybind. The config is reloaded the moment you save it.
Start a section with name { and end in } in separate lines!
The default config is not complete and does not list all the options / features of Hyprland. Please refer to this wiki page and the pages linked further down here for full configuration instructions.
Make sure to read the “Variables” page as well. It covers all the toggleable / numerical options.
Every config line is a command followed by a value.
COMMAND=VALUE
The command can be a variable, or a special keyword (described further in this page)
You are allowed to input trailing spaces at the beginning and end.
e.g.:
COMMAND = VALUE
is valid.
Comments are started with the # character.
If you want to escape it (put an actual # and not start a comment)
you can use ##. It will be turned into a single # that WILL be a part of your
line.
To configure the “options” of Hyprland, animations, styling, etc. see Variables.
Some keywords (binds, curves, execs, monitors, etc.) are not variables but define special behaviour.
See all of them in Keywords and the sidebar.