Configuring Hyprland
The config is located in ~/.config/hypr/hyprland.conf.
I recommend you copy the examples/hyprland.conf, but you can also edit the
autogenerated config.
By removing the line autogenerated=1 you’ll remove the yellow warning.
There is no “reload” keybind. The config is reloaded the moment you save it.
Start a section with name { and end in } in separate lines!
The default config is very barebones. Please refer to this wiki page and the pages linked further down here for full configuration instructions.
Make sure to read the “Variables” page as well. It covers all the toggleable / numerical options.
every config line is a command followed by a value.
COMMAND=VALUE
The command can be a variable, or a special keyword (described further in this page)
You are allowed to input trailing spaces at the beginning and end.
e.g.:
COMMAND = VALUE
is valid.
To configure the “options” of Hyprland, animations, styling, etc. see Variables.
Some keywords (binds, curves, execs, monitors, etc.) arent variables but define special behaviour.
See all of them in Keywords and the sidebar.